The B06.08 granulator is designed for the granulation of small sprues. Typical applications are the granulation of CD sprues and small sprues from microinjection moulding.

The granulator type B06.08CD is specially designed for the granulation of CD sprues, while the modell B06.08S is designed for general microinjection moulding applications .
The cutting chamber of the B Series granulators including rotor and screen are made of stainless steel, to fulfill also high purity standards for regrind. In addition, the cutting chamber is hermetically sealed to prevent the regrind from being contaminated by incoming air or dust when extracted by suction. It is therefore possible to use this granulator under clean room conditions, as is typical in CD production.

Both models granulate sprues at low speed. This ensures a virtually dust-free regrind as well as maintaining a very low noise level.
The optimized geometry of the V-formation scissors cut and the cascading, multi-level rotor is providing a very effective granulation process and therefore the power required by the geared motor is reduced without compromising granulator efficiency.
The Baby Series offers the optimal solution for the granulation of small sprues for microinjection moulding and CD production.